Material | Powder Coated Steel |
Input Voltage | 120V 60Hz 0.33A |
Output Voltage | 12V AC/ 15V AC |
Core Type | Magnetic |
Capacity | 200w Max |
Controllers | Built-in Photocell & Hour Timer |
Protection | Thermal Circuit Breaker |
Dimensions | 11.35" X 4.05" X 4.05" |
Certifications | ETL/cETL Listed for Wet Locations / Outdoor Rated |
Product Dimensions

A. Set three position switch to HI or LOW position.
B. Push in all trippers on dial between desired 'ON' time.
C. Turn dial clockwise until time arrow is pointing at correct time of day.
2. AUTOMATIC CONTROL WITH PHOTOCELL:
A. Remove protective cover from photocell.
B. The HI or LOW position on the three position switch will activate both the timer and the photocell. To control lights - set the timer to turn on before dark and the photocell will activate the lights when it gets dark. Lights can be turned off by the timer at the pre-set time, or push in all trippers and photocell will turn off lights at dawn.
3. CIRCUIT BREAKERS:
A. A circuit breaker will trip oif there is a short or if total lamp wattage installed exceeds rating.
B. To reset breaker - turn breaker to 'ON' position.
C. If breaker trips again, check for an overload or a short circuit.
4. NOTES
Photocell has a delay up to 60 +40/-20 seconds.